Column Pipes

PRESMAK INTERNAL SEALED COLUMN PIPES

PRESMAK Plastik started production with an internal gasket in PVC column pipe as a result of research and tests carried out by the R&D department and it has been working on for a long time. With special raw materials and special system in pipe production, plastic column pipes with internal seals, whose durability and load pulling power are increased, are now at the service of our customers. PRESMAK internally sealed column pipes are produced by passing the quality control processes in fully automated computerized production lines by making the necessary tests in laboratories and other approved laboratories with high quality and meticulousness, which is always the motto of our company, and with the necessary care at every stage of production. It is released to the market. The tooth system of your pipes is produced as trapezoidal tooth and it is easy to assemble and disassemble. In our pipes, by using two o-rings in the tooth part, sand, stone, etc. entry of items is prohibited. The O-ring channel has not been opened at the end of the threaded male head part because the impact strength of such pipes and the tensile strength of the pipes decreases over time, but the female head is opened to the thicker and stronger sleeve part. In this way, the pipes have a higher load-pulling capacity.

STANDART DALGIÇ KOLON BORUSU
ÇAP
(mm)
INCH
ET KALINLIĞI
(mm)
42
1 1/4"
5
50
1 1/2"
5,3
63
2"
6
75
2 1/2"
6,5
87
3"
7,5
113
4"
8,5
140
5"
11
180
6"
13
ALT - ÜST
ADAPTÖRLERİ
ÇAP
(mm)
INCH
42
1 1/4"
50
1 1/2"
63
2"
75
2 1/2"
87
3"
113
4"
140
5"
180
6"

INSTRUCTIONS FOR USING INTERNAL SEALED COLUMN PIPE

The surface must be clean and dry in the assembly of PRESMAK internally sealed column pipes.
Make sure the gasket is attached.
If the gasket is broken or damaged, replace it.
Do not use grease and oil, only water.
The pipes should be assembled to each other manually or with a belt tightening wrench. Do not use chain keys or metal materials.
Our pipes are manufactured according to a pressure of 250 meters (25 Bar) and in case of any manufacturing error, our pipes are under the warranty of our factory.

 

ADVANTAGES:

It is lightweight, easy to transport and easy to install.
Does not wear, does not require maintenance
It saves power.
It is an electric proof insulator.
It is long-lasting. (PVC pipes lifetime is at least 50 years if they are protected from proper use, storage, transportation and sunlight)
It is resistant to rusting and rotting.
There is no harm to human health. (A document was obtained from the non-hygienic health institute indicating that it has no effect on water.)
Friction loss is very low compared to metal.
It has high resistance against impacts.
Thanks to the double o-ring, the sealing rate is higher than other pipes.
Provides plus minus 30% increase in efficiency
It was resistant to sudden pressure increases and shocks.
Patented.
Pumps can be pulled and placed quickly without waiting.
Can be placed and dismantled, not affected by extreme weather conditions.
It is resistant to corrosion and abrasion of chemicals.
It provides energy savings in pumps.